Differences

This shows you the differences between two versions of the page.

--- startinglights [2013/08/24 23:10] – [Protocol] zround
+++ startinglights [2020/06/04 21:56] (current) – [Tested devices] zround
@@ Line 1: / Line 1: @@
-====== Starting Lights System ======
+====== Starting Lights Devices ======
-ZRound supports Starting Lights System. The protocol can be defined and two working modes are availables (master/slave).
+ZRound supports Starting Lights devices. The protocol can be defined and two working modes are availables (master/slave).
-Temperature and Humidity data can be sent to ZRound by using special commands to be displayed on screen.
+Temperature and Humidity data can be sent as well to ZRound by using special commands to be displayed on screen.
 ===== Protocol =====
-The protocolo includes the commands //START, STOP, GO, LIGHT, HT, HS// described below in its default values. The commands can be fully configured in the ZRound Starting Lights configuration page
+The protocol includes the commands //START, STOP, PAUSE, RESUME, GO, LIGHT, HT, HS// described below. The commands can be fully configured in the ZRound Starting Lights configuration page
 ==== Slave Mode ====
@@ Line 36: / Line 36: @@
   <n> is the light to be controlled
   <state> 0 off, 1 on
+</code>
+==== Race Pause & Resume ====
+Race can be paused and resumed from the device with the following commands.
+Device -> ZRound
+<code>
+  * PAUSE = $PAUSE
+  * RESUME = $RESUME
 </code>
@@ Line 53: / Line 62: @@
-===== Devices tested =====
+===== Tested devices =====
 * [[:StartingLights:KartingOcana|Arduino based system (Karting Ocaña - (c) Juan Pardo))]]
+* Patch to use a LEDSTRIP WS2811. [[https://www.zround.com/?smd_process_download=1&download_id=774|Descarga de código desde zround.com]]
 **[[info@zround.com?subject=New Starting Lights system for ZRound|Add your own device]]**