Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision |
| lapcounters:protocols:ricino [2020/06/24 22:14] – zround | lapcounters:protocols:ricino [2020/06/24 22:14] – zround |
|---|
| ^Sender^Command^Code^Description| | ^Sender^Command^Code^Description| |
| ^ZRound|Startup|%**C**&|ZRound tries to initialize the connection. It is used to verify the decoder is ready. The decoder must answer with an ACK within 500ms otherwise a timeout is fired and connection is discarded | | ^ZRound|Startup|%**C**&|ZRound tries to initialize the connection. It is used to verify the decoder is ready. The decoder must answer with an ACK within 500ms otherwise a timeout is fired and connection is discarded | |
| ^Ricino|Startup ACK|%**A**&|Acknowledge the %C& startup command within 500ms | | ^LapCounter|Startup ACK|%**A**&|Acknowledge the %C& startup command within 500ms | |
| ^ZRound|Race start|%**I**&|ZRound ask to start the race (clock must be set to zero) | | ^ZRound|Race start|%**I**&|ZRound ask to start the race (clock must be set to zero) | |
| ^ZRound|Race stopped|%**F**&|ZRound ask the bridge for stopping the race. No further detection should be sent | | ^ZRound|Race stopped|%**F**&|ZRound ask the bridge for stopping the race. No further detection should be sent | |
| ^Ricino|Clock|%**T**hhhhhh&|Clock signal used for sync PC and Decoder clocks. hhhhhh is time in milliseconds hexadecimal coded. Variable code length is allowed. All numbers from T to & is assumed to be the time info | | ^LapCounter|Clock|%**T**hhhhhh&|Clock signal used for sync PC and Decoder clocks. hhhhhh is time in milliseconds hexadecimal coded. Variable code length is allowed. All numbers from T to & is assumed to be the time info | |
| ^Ricino|Lap|%**L**TX[,]hhhhhh&|Lap detected \\ **TX**=transponder number in hexadecimal \\ * Two digits if "," si ommited \\ * Variable digit length if used "," as separator symbol \\ **hhhhhh**=race time in milliseconds (hexadecimal). \\ Variable time length is valid, time info is coded after TX and before the finish symbol "&" | | ^LapCounter|Lap|%**L**TX[,]hhhhhh&|Lap detected \\ **TX**=transponder number in hexadecimal \\ * Two digits if "," si ommited \\ * Variable digit length if used "," as separator symbol \\ **hhhhhh**=race time in milliseconds (hexadecimal). \\ Variable time length is valid, time info is coded after TX and before the finish symbol "&" | |
| | |
| |
