Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
startinglights [2013/08/24 23:10] – [Protocol] zround | startinglights [2020/06/04 21:56] (current) – [Tested devices] zround | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Starting Lights | + | ====== Starting Lights |
- | ZRound supports Starting Lights | + | ZRound supports Starting Lights |
- | Temperature and Humidity data can be sent to ZRound by using special commands to be displayed on screen. | + | Temperature and Humidity data can be sent as well to ZRound by using special commands to be displayed on screen. |
===== Protocol ===== | ===== Protocol ===== | ||
- | The protocolo | + | The protocol |
==== Slave Mode ==== | ==== Slave Mode ==== | ||
Line 36: | Line 36: | ||
<n> is the light to be controlled | <n> is the light to be controlled | ||
< | < | ||
+ | </ | ||
+ | |||
+ | ==== Race Pause & Resume ==== | ||
+ | Race can be paused and resumed from the device with the following commands. | ||
+ | |||
+ | Device -> ZRound | ||
+ | < | ||
+ | * PAUSE = $PAUSE | ||
+ | * RESUME = $RESUME | ||
</ | </ | ||
Line 53: | Line 62: | ||
- | ===== Devices tested | + | ===== Tested devices |
* [[: | * [[: | ||
+ | |||
+ | * Patch to use a LEDSTRIP WS2811. [[https:// | ||
**[[info@zround.com? | **[[info@zround.com? | ||
+ |