Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
startinglights [2013/08/24 22:50] – [Devices tested] zround | startinglights [2020/06/04 21:56] (current) – [Tested devices] zround | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Starting Lights | + | ====== Starting Lights |
- | ZRound supports Starting Lights | + | ZRound supports Starting Lights |
- | Temperature and Humidity data can be sent to ZRound by using special commands to be displayed on screen. | + | Temperature and Humidity data can be sent as well to ZRound by using special commands to be displayed on screen. |
===== Protocol ===== | ===== Protocol ===== | ||
+ | |||
+ | The protocol includes the commands //START, STOP, PAUSE, RESUME, GO, LIGHT, HT, HS// described below. The commands can be fully configured in the ZRound Starting Lights configuration page | ||
==== Slave Mode ==== | ==== Slave Mode ==== | ||
Line 36: | Line 38: | ||
</ | </ | ||
- | ===== Devices tested | + | ==== Race Pause & Resume |
+ | Race can be paused and resumed from the device with the following commands. | ||
+ | |||
+ | Device -> ZRound | ||
+ | < | ||
+ | * PAUSE = $PAUSE | ||
+ | * RESUME = $RESUME | ||
+ | </ | ||
+ | |||
+ | ==== Temperature / Humidity ==== | ||
+ | |||
+ | The protocol supports sending temp/hum. data in order to be shown on screen. There are available these commands: | ||
+ | |||
+ | < | ||
+ | * HS = $HS,< | ||
+ | * HT = $HT,< | ||
+ | </ | ||
+ | |||
+ | where | ||
+ | < | ||
+ | <n> is the humidity/ | ||
+ | </ | ||
+ | |||
+ | |||
+ | ===== Tested devices | ||
* [[: | * [[: | ||
+ | |||
+ | * Patch to use a LEDSTRIP WS2811. [[https:// | ||
+ | |||
+ | **[[info@zround.com? | ||
+ |